BP10™/CP10™ COMPRESSOR REPLICA RTS PCB

The ready-to-solder PCB for our Ibanez™ BP10™ / CP10™ compressor replica: one board builds either the bass or the guitar version of this underrated compressor.

About this PCB

The Ibanez™ CP10™ guitar compressor and BP10™ bass compressor are nearly identical circuits that differ by only two capacitor values, so this one PCB builds either. Both are very good, underrated compressors. The original "10" series picked up a poor reputation because its plastic jacks and plastic-shafted pots make repairs hard or impossible; building the replica on this board lets you skip those weak points.

Jumpers are included in the top layer, so there is no need to solder in any jumpers.

Specs

• PCB size: 5.8cm x 4.4cm
• Solder mask, plated-through holes and silkscreened part placement
• Jumpers built into the top layer

Also builds

• CP10™ guitar compressor
• BP10™ bass compressor

Build resources

• Complete instructions for the CP10™ Compressor
• Complete instructions for the BP10™ Bass Compressor

Trademarks mentioned here belong to their owners, not General Guitar Gadgets.